Filter
Top Products
93
Menu Description
Advanced Guide Menu Description
User screen settings
> [System settings] > [User screen settings]
Capture a logo and specify logo display settings.
Logo capture
Registers the current image as a user logo. Registered user logos can be shown when no
signal is received, when the BLANK button is pressed, or as the startup image.
Option Function
OK
Display the image for logo registration.
Align the image with the red boundary lines indicating the portion that
will be stored, and then press the OK button. The portion of the image
within the boundary lines is now registered.
Cancel Cancels logo registration.
Logo position
Specify the position of registered user logos as follows.
You can specify the position after a logo has been registered. Choose from upper left, upper
right, center, lower left, or lower right.
No signal screen
Customize the screen shown when no input signals are received.
Option Function
Black The screen is all black.
Blue The screen is all blue.
User logo The user logo is projected.
Screen when blank
Select the screen shown when projection is temporarily blanked out by pressing the BLANK
button on the remote control.
Option Function
Black The screen is all black.
Blue The screen is all blue.
User logo The user logo is projected.
Projector on
Select a logo to show after startup while the projector is warming up.
Option Function
Skip Project input signals immediately after startup.
Canon logo Displays the Canon logo that was registered in advance at the factory.
User logo The user logo is projected.