Filter
Top Products
21
E
■ FULL+HALF CUT
• FULL+HALF CUT perform a full cut at the end of each label, and a half cut
near the beginning of each label to make the backing paper easier to remove.
F
o
r
S
a
l
e
F
o
r
S
a
l
e
■ FULL CUT
• FULL CUT performs a full cut at the end of each label.
• Use this setting when printing on iron transfer tape.
• When using the NARROW and MEDIUM margin settings, this setting
automatically performs a full cut to trim off excess tape.
F
o
r
S
a
l
e
F
o
r
S
a
l
e
■ UNCUT
• When UNCUT is selected, the printer does not perform any cut operation
between labels.
• This setting is best when you want to print labels without spaces between
them, which saves label tape.
• Be sure to select UNCUT when printing on magnetic tape and reflective
tape. After printing is complete, press FEED to feed the tape, and then cut it
with a pair of scissors.
F
o
r
S
a
l
e
F
o
r
S
a
l
e
F
o
r
S
a
l
e
F
o
r
S
a
l
e
Using Magnetic Tape and Reflective Tape
Special handling is required when printing on magnetic tape and reflec-
tive tape. Whenever printing on magnetic tape or reflective tape, select
UNCUT as the tape cut mode, and cut the tape using a pair of scissors
as described below.
Important!
• Using the printer's built-in cutter to half cut or full cut magnetic tape or
reflective tape will shorten the service life of the cutter blade, and can
damage the cutter mechanism.
1. Select NONE for the MARGINS setting (page 29), or UNCUT for
the tape cut mode.
2. Print the tape.
3. Press FEED to feed the tape.
4. Use a pair of scissors to cut the tape.