Filter
Top Products
11
First Wireless LAN Connection between the Data
Projector and Four Computers
The following procedure uses the initial default settings of the Manual Connection 1
connection profile to establish wireless LAN connections between the Data Projector and
four computers for the first time.
Important!
z The XJ-S35/YP-100 does not have manual connection initial values registered. Before
performing the following procedure, use the procedure under “Sending Settings from a
Computer to the Data Projector” (page 34) to send Manual Connection 1 profile
settings from your computer to the projector.
z You should use Wireless Connection 2 on all of the computers connecting to the
Data Projector. Do not use an older version of Wireless Connection.
To change the Data Projector connection profile to Manual Connection 1
1
Turn on the Data Projector and connect the CASIO YW-2 wireless adapter to the
Data Projector’s USB port.
z This will start up Wireless automatically and display the “Standing by for connection...”
message on the projection screen.
2
On the Data Projector’s remote controller, press the [] key.
z This will cause the connection profile menu to appear in the projection area.
3
Press the [T] key three times to move the highlighting to “Manual Connection
1” and then press the [ENTER] key.
z This will display a connection profile change confirmation dialog box.
4
Press the [S] key to move the highlighting to “Yes” and then press the [ENTER]
key.
z This will close the confirmation dialog box and return to the “Standing by for
connection...” message.
z Next, perform the procedure under “To establish a wireless LAN connection with Manual
Connection 1 between the first computer and the Data Projector” below.
Using a Manual Connection Profile for Wireless LAN
Connection between the Data Projector and One or
More Computers