Filter
Top Products
30
Creating a Computer Connection Profile
After you modify the settings of the Data Projector’s manual setting profile, you will also
need to modify the existing wireless LAN connection settings (connection profile) of the
computer accordingly, or you will have to create a new connection profile. This section
explains the procedure for using Wireless Connection 2 to create a new profile or to
modify the existing profile of a computer.
To create a new computer connection profile
Note
This procedure shows how to create a new computer connection profile to match
modifications made in the settings of the Data Projector’s connection profile named
“Manual Connection 3”. In this example, the projector’s name (page 26) is “Projector A”.
1
Perform the procedure under “To modify Data Projector manual connection
settings” (page 29) to modify Data Projector’s “Manual Connection 3” profile
settings as shown below.
z The above settings are provided as an example only. When you are establishing a
wireless LAN connection using the Access Point Mode, you need to configure settings to
match the actual access point. When configuring the IP address of the Data Projector
(and the computer connecting to the Data Projector over the wireless LAN connection),
you need to make sure that the IP address of the access point is different from all other
IP addresses within the same network.
z For details about each of the settings on the dialog box, see “Manual Connection Setting
Reference” (page 40).
Dialog Box Item Setting
Profile Name RoomB
SSID ROOM_B
Access Mode Ad Hoc
Security Setup WEP
WEP Key Format ASCII/128bit
WEP Key/WPA/WPA2 Pass Phrase 1234567890abc
DHCP Off
IP Address 192.168.10.1
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Channel Auto