Filter
Top Products
35
6
Enter the password and then click the [OK] button.
7
Keep clicking the [OK] button on the dialog boxes that appear.
z Clicking the [OK] button in response to the “Overwrite it?” message will cause the
settings of the computer to be sent to the Data Projector. This will cause the Data
Projector manual connection profile you selected in step 5 to be overwritten with the
connection profile settings you selected in step 3. Note, however that the IP address of
the Data Projector will become the IP address of the computer plus 1.
Note
You can change the projector’s IP address by clicking the [Send Options] setting on the
“Send Settings” dialog box.
8
To return to the Send Settings dialog box, click the [Cancel] button.
z This will return to the Switch Connection Profile dialog box.
9
Click the [Close] button.
z This will return to the Wireless Connection 2 window.
Note
After performing the above operation to send manual connection profile settings, perform
the following steps to establish a wireless LAN connection between the Data Projector
and the computer that is using the sent settings.
1. On the Wireless Connection 2 window, click the button to terminate the
connection.
2. Change the Data Projector connection profile to the manual connection profile you
selected in step 5 of the above procedure.
z For more information, see “To switch the Data Projector connection profile” (page 24).
3. On the Wireless Connection 2 window [Connection] menu, select [Switch Connection
Profile] to switch the computer connection profile to the manual connection profile you
selected in step 3 of the above procedure.