7
Chapter 7 Print Control Codes
92
m Function
0,30 Full Cut
1,31 Partial Cut (1 point left)
41
(Cutting position + [n x basic calculation pitch] )
paper feed and full cut.
42
(Cutting position + [n x basic calculation pitch] )
paper feed and partial cut (1 point left).
(58) Cutting of paper (GS V m, GS V m n)
Code: (1) [1D] h + [56] h + m
(2) [1D] h + [56] h + m + n
* (1) (0 ≤ m ≤ 1)
(30 ≤ m ≤ 31) Data are expressed in Hex code.
(2) (41 ≤ m ≤ 42)
(0 ≤ n ≤ FF) Data are expressed in Hex code.
This command executes the specified paper cut.
• In the Standard mode, this command is valid only if it is input at the head of the
line.
In the case of (1):
• When m = 1 or m = 31, a partial cut (1 point left) is executed.
In the case of (2):
• When n = 0, after executing paper feed to the cutting position, the paper is cut.
• When n ( 0, after executing paper feed [n x basic calculation pitch] inch from
the cutting position, the paper is cut.
• The basic calculation pitch is set by GS P.
• The paper feed amount is calculated by the vertical basic calculation pitch (y).
Also, if there is a fraction, interpolation is carried out at the mechanism's mini-
mum pitch. Remainders are cut off.