Filter
Top Products
7
89
Printable Range
Width of Print Area
Left Margin
• This command is valid only when input at the head of a line.
• When Page mode is selected, if this command is input, the printer's internal flag
operation only is executed.
• Setting of this command has no influence on the Page mode.
• The maximum settable left margin is the same as the area in the horizontal direc-
tion that can be printed. Settings that exceed the maximum value are rounded to
the maximum value.
• The basic calculation pitch is set by GS P. Also, once the left margin is set, it will
not change even if the basic calculation pitch is changed by GS P.
• The horizontal basic calculation pitch (x) in GS P is used in calculating the left
margin. Also, if there is a fraction, interpolation is carried out at the mechanism's
minimum pitch. Remainders are cut off.
• The left margin is set for the set sheet selected as valid by ESC c 1.
• The left margin can be set independently for the receipt and journal printers, but if
printing of the same data in the receipt and journal printers is specified, the left
margin set in the journal printer is disregarded and that set in the receipt printer is
enabled.
• The initial values are “n1 = 0” and “n2 = 2”.
Input Data Format
(55) Setting the left margin (GS L n1 n2)
Code: [1D] h + [4C] h + n1 + n2
* (0 ≤ n1 ≤ FF)
(0 ≤ n2 ≤ FF) Data are expressed in Hex code.
This command sets the left margin specified by n1 and n2.
The left margin is [(n1 + n2 x 256) x basic calculation pitch] inch.