Filter
Top Products
Cautions for Installation
• Do not use or store this product in a place where there is fire or water vapor, where it
will be exposed to direct sunlight, in a place where it will be exposed to heat or
humidity conditions that it was not specified for, such as next to a heater or burner, or
a place where there is a lot of oil, iron filings, dust or dirt, etc. Doing so could cause
it to break down, emit smoke or catch fire.
• Do not install this product in a place such as an experimental laboratory where there
are chemical reactions taking place, or where there is salt or gas in the air. This could
cause fire or electric shock.
• Install on a level, stable table which doesn't vibrate, in a location where there is good
ventilation. (Do not cover the air holes.)
• Do not place any articles on top of the printer. It could cause it to break down.
• Do not use this printer near, or plug it into the same outlet with, a radio or television
receiver. Doing so could interfere with reception.
• Do not use this product at a voltage and frequency other than the specified voltage
and frequency.
• Make sure the circuit where this printer is plugged in has sufficient surplus capacity to
operate this printer without trouble.
• Avoid attaching this printer's power cord to an overloaded electric circuit. If the circuit
is overloaded, it could cause the electric line to overheat and cause a fire, or trip the
circuit breaker. Also, do not walk on the power cable or place objects on top of it.
• When disconnecting cables, always switch off the power first, then take hold of the
plug or connector and disconnect them. Do not pull on this product while a heavy
weight is bearing on the cables or attempt to carry it by holding the cables.
• Connect the cable connectors securely. Particularly, if the cables are connected with
the polarity reversed, it could destroy the internal components, and also have a bad
effect on the device on the other end of the cable.
• In order to avoid garbling of data, etc. due to noise, always use shielded signal lines
or twisted pair lines. Also, please avoid connecting this printer with a device that
generates a lot of noise.
• Use this printer in a place where it is near to an outlet, and the power plug can be
pulled out easily, and under conditions where the power supply can be cut off easily.