Filter
Top Products
7
Chapter 7 Print Control Codes
82
Japan CBM
813 (3200) 6293
813 (3200) 6293
Japan CBM
(46) Specifying/Clearing printing of the same data by the receipt
and journal printers (ESC z n)
Code: [1B] h + [7A] h + n
* (0 ≤ n ≤ FF) Data are expressed in Hex code.
This command specifies and clears the printing of the same data by the receipt and
journal printers.
• In n, the least significant bit (n0) becomes enabled.
• The least significant bit (n0) is as follows.
n0 = 0: Printing of the same data is cleared.
n0 = 1: Printing of the same data is specified.
• This command is valid when it is input at the head of a line.
• Even if printing of the same data is specified, if both the receipt and journal print-
ers are not selected as the printing sheet, the printing will not be the same for both
printers.
• When Page mode is selected, this command is disabled.
• The initial value is “n0 = 0”.
(47) Specifying/Clearing inverted characters (ESC { n)
Code: [1B] h + [7B] h + n
* (0 ≤ n ≤ FF) Data are expressed in Hex code.
In n, the least significant bit (n0) becomes enabled.
• The least significant bit (n0) is as follows.
n0 = 0: Inverted characters are cleared.
n0 = 1: Inverted characters are specified.
• This command is valid when it is input at the head of a line.
• If this command is input when Page mode is selected, the printer's internal flag
only operates, and there is no influence in the Page mode.
• The initial value is “n0 = 0”.
• The following shows a printing example.
If inverted characters are cleared: If inverted characters are specified:
Paper Feed Direction