Filter
Top Products
User’s Guide 21020285 D
Appendix A Error Codes
Summary Page A - 5
36H
Target Mode Message
Out Limit Exceeded
The adapter received and rejected unsupported or illegal message
bytes from the initiator until the Message Out Phase limit was
exceeded.
37H
Target Mode Message
Protocol Error
The initiator violated message protocol by sending an Identify and
only one more byte, or by holding ATN after a message that is
required to be the last in a sequence.
39H
SCSI Chip Target
Mode Command
Timeout
A Target Mode command to the FAS256 did not complete within
the allowed time.
3AH
SCSI Chip Target
Mode Command
Rejected
A Target Mode command to the FAS256 was rejected because of a
gross error or an illegal trap.
3BH Command Abort
This command was terminated by the RF3880 Board-control Abort
command.
3CH
Abort Command
Failure
The Abort command could not abort the specified command.
8EH Bad Task
This error code indicates the occurrence of an Internal Firmware
error detected by the adapter.
*96H
Internal Firmware
Error
This error code indicates that a Firmware error was detected during
the execution of a command.
A1H
Invalid Unit Options
Sense Count Value
A value greater than 32 was placed in the Sense Count field of a Unit
Options or Extended Unit Options command. Valid values for this
field are 0 to 32.
Code Name Description
Table 116: Error Codes