Filter
Top Products
User’s Guide 21020285 D
Chapter 5 Initiator Mode Pass-through Commands
Initiator Pass-through Status Block Format Page 5 - 13
CSB Continued Status Block - This bit indicates that the current Status
Block is one of several Status Blocks generated because extended Sense Bytes
are enabled. Only valid for Pass-through commands issued through Command
List.
0 ⇒ Status Block is first (or only) Status Block
1 ⇒ Status Block is one of a series of Status Blocks.
DTG Data Transfer Greater - Indicates when an Initiator Pass-through
command completes with more bytes requested by the SCSI device than was
specified in the Transfer Count field.
0 ⇒ Data transfer was not greater.
1 ⇒ Data transfer was greater.
DTT Data Transfer Truncated - Indicates when an Initiator Pass-through
command completes with fewer bytes transferred than requested in the Transfer
Count field.
0 ⇒ Data transfer was not truncated.
1 ⇒ Data transfer was truncated.
RTY Retry - Indicates whether an Initiator Pass-through command required
retries to complete.
0 ⇒ No retries were required.
1 ⇒ Retries were required to complete.
ERR Error Status - Identifies when a command, Board-control or Pass-
through, completes with an error.
0 ⇒ No error occurred.
1 ⇒ An error occurred.
CC Command Complete - Indicates whether a command has finished.
0 ⇒ Command not complete.
1 ⇒ Command complete.
Error
When an adapter-detected error occurs, this byte contains an error code to
describe the condition. See Appendix A.