Filter
Top Products
21020285 D User’s Guide
Chapter 3 Hardware Installation
Page 3 - 6 Step 2: Jumpers and Termination
SCSI
Configuration
Jumpers
This block of jumpers is used to select power-up defaults for:
• Adapter SCSI ID
• SCSI Bus reset on power-up and system reset
• SCSI Bus Parity
The SCSI Configuration jumper block is illustrated below:
Figure 4 SCSI Configuration Jumper Block
The default settings of the jumper block are shown in the above figure and the
table below.
Pins Description Default
1-2
Reserved
OUT
3-4 OUT
5-6 Enable SCSI Parity Checking OUT = Selected
7-8 SCSI bus Reset at Power-up OUT = Selected
9-10 SCSI ID Bit 3
Table 13: Default Jumper Settings