Cisco Systems 1200 Network Card User Manual


 
B-2
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Appendix B Declarations of Conformity and Regulatory Information
Manufacturers Federal Communication Commission Declaration of Conformity Statement
Manufacturers Federal Communication Commission
Declaration of Conformity Statement
Autonomous Access Point Models:
AIR-AP1200 with AIR-MP20B-A-K9 and/or AIR-RM20A-A-K9;
AIR-AP1210 with AIR-MP20B-A-K9 or AIR-MP21G-A-K9, and/or AIR-RM20A-A-K9 or
AI
R-RM21A-A-K9 or AIR-RM22A-A-K9;
AIR-AP1220B-A-K9, AIR-AP1230B-A-K9, AIR-AP1220A-A-K9, AIR-AP1230A-A-K9, or
AIR-AP1231G-A-K9
AIR-AP1232AG-A-K9
Lightweight Access Point Models:
AIR-LAP1231G-A-K9;
AIR-LAP1232AG-A-K9
FCC Certification number:
LDK 102042 (AIR-MP20B-A-K9) or
LDK 102049 (AIR-MP21G-A-K9) and/or
LDK 102045 (AIR-RM20A-A-K9)
LDK 102053 (AIR-RM21A-A-K9 and AIR-RM22A-A-K9)
Manufacturer:
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
t
o Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates,
uses, and radiates radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference. However, there is no guarantee that interference will not
occur. If this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE