Filter
Top Products
B-7
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-8370-04
Appendix B Declarations of Conformity and Regulatory Information
Declaration of Conformity for RF Exposure
Note Combinations of power levels and antennas resulting in a radiated power level above 100 mW equivalent
isotropic radiated power (EIRP) are considered as not compliant with the above mentioned directive and
are not allowed for use within the European community and other countries that have adopted the
European R&TTE directive 1999/5/EC or the CEPT recommendation Rec 70.03 or both. For more
details on legal combinations of power levels and antennas, refer to the Appendix D, “Channels and
Maximum Power Levels.”
For 54 Mbps, 5 GHz access points, the following standards were applied:
• Radio: EN 301.893
• EMC: EN 301.489-1, EN 301.489-17
• Safety: EN 60950
The following CE mark is affixed to the 54 Mbps, 5 GHz access points:
• For AIR-RM20A (not supported on the AIR-LAP1232AG-A-K9)
• For AIR-RM21A and AIR-RM22A
Declaration of Conformity for RF Exposure
The radio module has been found to be compliant to the requirements set forth in CFR 47 Sections
2.1091, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices as defined in
Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic
Fields. For the IEEE 802.11B antennas, AIR-ANT24120, AIR-ANT4121 and AIR-ANT1949 the
equipment should be positioned more than 2 m (6.56 ft) from your body or nearby persons. For all other
approved antennas the equipment should be installed more than 20 cm (7.9 in.) from your body or nearby
persons.
The access point (with 5 GHz integrated antenna) must be installed to maintain a minimum 20 cm
(7.9 in.) co-located separation distance from other FCC approved indoor/outdoor antennas used with the
a
ccess point. Any antennas or transmitters not approved by the FCC cannot be co-located with the access
point antennas. The access point’s co-located 2.4 GHz (2.2 dBi) and 5 GHz integrated antennas support
a minimum separation distance of 10 cm (3.9 in.) and are compliant with the applicable FCC RF
exposure limit when transmitting simultaneously.
Note Dual antennas used for diversity operation are not considered co-located.
49325