Filter
Top Products
5-4
Hardware Installation Guide for Cisco Media Experience Engine 3000
OL-17000-01
Chapter 5 Troubleshooting the Cisco MXE 3000
Power-On Self Test (POST)
POST Error Codes
The error messages and codes in this section include all messages generated by the Cisco MXE 3000
appliance. Some messages are informational only and do not indicate any error. A server generates only
the codes that are applicable to its configuration and options.
Warning
To avoid potential problems, ALWAYS read the warnings and cautionary information in the server
documentation before removing, replacing, reseating, or modifying system components
Advanced Memory Protection mode: Advanced ECC
Possible Cause: Advanced ECC support is enabled.
Action: None.
Advanced Memory Protection mode: Advanced ECC with hot-add support
Possible Cause: Advanced ECC with Hot-Add support is enabled.
Action: None.
Advanced Memory Protection mode: Online spare with Advanced ECC
...Xxxx MB System memory and xxxx MB memory reserved for Online Spare.
Possible Cause: This message indicates Online Spare Memory is enabled and indicates the amount of
memory reserved for this feature.
Action: None.
Advanced Memory Protection mode: Multi-board mirrored memory with Advanced ECC
...Xxxx MB System memory and xxxx MB memory reserved for Mirroring.
Possible Cause: This message indicates Mirrored Memory is enabled and indicates the amount of
memory reserved for this feature.
Action: None.
Advanced Memory Protection mode: RAID memory with Advanced ECC
...Xxxx MB System memory and xxxx MB memory reserved for RAID.
Possible Cause: This message indicates RAID Memory is enabled and indicates the amount of memory
reserved for this feature.
Action: None.
An Unexpected Shutdown occurred prior to this power-up
Possible Cause: The server shut down because of an unexpected event on the previous boot.
Action: Check the System Management Log or OS Event Log for details on the failure.
Critical Error Occurred Prior to this Power-Up
Possible Cause: A catastrophic system error, which caused the server to crash, has been logged.
Action: If the problem persists contact your Cisco representative to arrange for repair.