Filter
Top Products
CHAPTER
4-1
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
OL-24619-02
4
Installing Hardware Options for the WAVE-594
and WAVE-694
This chapter provides basic instructions for installing hardware options in your WAVE-594 and
WAVE-694. These instructions are intended for technicians who are experienced with setting up Cisco
WAVE-594 and WAVE-694 hardware.
This chapter contains the following sections:
• Installing a Cisco WAVE Interface Module, page 4-1
• Replacing a Hard Disk Drive/Solid State Drive, page 4-2
• Replacing a Fan, page 4-4
• Replacing a Power Supply, page 4-5
• Installing Memory, page 4-6
Installing a Cisco WAVE Interface Module
In addition to the two onboard Gigabit Ethernet ports, the WAVE-594 and WAVE-694 can accommodate
one optional Interface Module network module:
• 4-port Gigabit Ethernet Copper Bypass Interface Module
• 8-port Gigabit Ethernet Copper Bypass Interface Module
• 4-port Gigabit Ethernet Fiber Optic Bypass Interface Module
• 2-port 10 Gigabit Ethernet Fiber Optic SPF+ Interface Module
For information on the features of the Cisco WAVE Interface Modules and cabling requirements, see
Chapter 5, “WAVE Interface Modules.”
Note Interface Modules are not hot-swappable therefore it is necessary to power the system down before
installing or replacing.
Caution To maintain proper system cooling, do not operate the appliance for more than 1 minute without either
an Interface Module or a filler panel installed in the bay.
To install a Cisco Interface Module in the Interface Module slot, follow these steps: