Filter
Top Products
1-47
Cisco 7200 VXR Installation and Configuration Guide
OL-5013-08
Chapter 1 Cisco 7200 VXR Product Overview
Field-Replaceable Units
Note An MII LINK LED is not provided on this I/O controller because the LED is provided on external
transceivers that are required for connecting to the MII receptacle on the I/O controller. See Chapter 3,
“Installing a Cisco 7200 VXR Router,” the “Connecting to the I/O Controller Ethernet and Fast Ethernet
Ports” section on page 3-30 for Fast Ethernet MII connection requirements.
Input/Output Controller C7200-I/O-FE-MII LEDs
Figure 1-26 shows the LEDs on the I/O controller with the Fast Ethernet port equipped with a single MII
receptacle (C7200-I/O-FE-MII), andTable 1-30 liststhe LEDsspecific to this I/Ocontroller model. Also
see Table 1-24 for LEDs common to all I/O controllers.
Figure 1-26 C7200-I/O-FE-MII LEDs and CPU Reset Button
Port Adapters and Service Adapters
The port adapters and service adapters installed in the Cisco 7200 VXR routers are of the same type as
those installed on the second-generation Versatile Interface Processors (VIPs) in the Cisco 7500 series
routers, in Cisco 7000 series routers with the Cisco 7000 series Route Switch Processor (RSP7000) and
Cisco 7000 series Chassis Interface (RSP7000CI), in the Cisco AS5800 Universal Access Server, and in
the Cisco uBR7246 universal broadband router.
Table 1-30 C7200-I/O-FE-MII I/O Controller LEDs
LED Color Function
FE ENABLE Green Indicatesthat the Fast Ethernet port is initialized and enabled for operation
by the system. ThisLED comeson after theI/O controller hasbeen enabled
and remains on during normal operation of the router.
FE LINK Green Indicates that the Fast Ethernet port has established a valid link with the
network. This LED remains off during normal operation of the router
unless there is an incoming carrier signal.
H6523
FE
ENABLE
SLOT 1
SLOT 0
FE LINK
CPU RESET
IO POWER OK
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
ENABLED