Filter
Top Products
Chapter 2 Configuring User Profiles and CSS Parameters
Boot Configuration Mode Commands
2-24
Cisco Content Services Switch Basic Configuration Guide
78-11424-03
Configuring Network Boot for a Passive SCM
To configure network boot for a CSS 11800 passive SCM:
1. Configure an FTP record for the passive SCM, if not already configured.
Refer to “Configuring a Boot Configuration Record for the Passive SCM” in
this chapter.
2. Ensure the passive SCM management port has access to the network drive
from which you are booting the CSS. If the primary SCM fails, the passive
SCM will connect to the remote disk and load the software configuration.
3. Configure the CSS to boot from a network drive. For example, enter:
(config-boot)# passive primary boot-type boot-via-network
bootrecord
To display a list of configured ftp records, reenter the command and use a “?”.
For example, enter:
(config-boot)# passive primary boot-type boot-via-network
bootrecord ?
4. Optionally, configure a primary configuration path to allow multiple CSSs to
use the same boot image while keeping their configuration information in
separate directories. Your FTP daemon mustsupport the drivemapping. Also,
the CSS must be able to access the configuration path through the FTP server
as defined in the FTP record. For example, enter:
(config-boot)# primary config-path e:/adi_directory/