Filter
Top Products
Chapter 2 Configuring User Profiles and CSS Parameters
Finding an IP Address
2-38
Cisco Content Services Switch Basic Configuration Guide
78-11424-03
Finding an IP Address
Use the find ip address command to search the CSS configuration for the
specified IP address. You can include a netmask for subnet (wildcard) searches.
This search can help you avoid IP address conflicts when you configure the CSS.
When you use this command, it checks services, source groups, content rules,
ACLs, the management port, syslog, APP sessions, and local interfaces for the
specified IP address. If the address is found, the locations of its use are displayed.
If no addresses are found, the CSS returns you to the command prompt.
This command is available in all modes. The syntax is:
find ip address ip_or_host {subnet_mask|range number}
Enter the:
• IP address in dotted-decimal notation (for example, 192.168.11.1) or enter
the host name in mnemonic host-name format (for example,
host.domain.com).
• Optional subnet mask as either:
–
A prefix length in CIDR bitcount notation (for example, /24). Do not
enter a space to separate the IP address from the prefix length.
–
An IP address in dotted-decimal notation (for example, 255.255.255.0).
If you enter a mask of 0.0.0.0, the CSS finds all addresses.
• range number todefine how many IP addresses youwant to find, starting with
the ip_or_host address. Enter a number from 1 to 65535. The default range is
1.
For example, if you enter an IP address of 203.1.1.1 with a range of 10, the
CSS tries to find the addresses from 203.1.1.1 through 203.1.1.10.
For example, enter:
(config)# find ip address 192.168.0.0
Users of IP address 192.168.0.0
Content Rule - 192.168.12.1, layer 3, owner: lml, state:Active
Content Rule - 192.168.12.1, layer 5, owner: lml, state:Active
Service - 192.168.3.6, serv1, state:Active
Service - 192.168.3.7, serv3, state:Active
Interface - 192.168.1.117. VLAN1
Interface - 192.168.2.117. VLAN1