Filter
Top Products
2-27
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 2 Alarm Troubleshooting
2.7.22 AUD-LOG-LOW
You do not have to assign an extension to the file. It is readable in any application that supports text files,
such as WordPad, Microsoft Word (imported), etc.
Step 6 Click Save.
The 640 entries are saved in this file. New entries continue with the next number in the sequence, rather
than starting over.
Step 7 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1-800-553-2447).
2.7.22 AUD-LOG-LOW
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Object: NE
The Audit Trail Log Low condition occurs when the audit trail log is 80 percent full.
Note AUD-LOG-LOW is an informational condition and does not require troubleshooting.
2.7.23 AUTOLSROFF
The AUTOLSROFF ALARM is not used in the ONS 15310 platforms in this release. It is reserved for
development.
2.7.24 AUTORESET
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
The Automatic System Reset alarm occurs when you change an IP address or perform any other
operation that causes an automatic card-level reboot.
AUTORESET typically clears after a card reboots (up to ten minutes). If the alarm does not clear,
complete the following procedure.
Clear the AUTORESET Alarm
Step 1 Determine whether additional alarms are present that could have triggered an automatic reset. If so,
troubleshoot these alarms using the applicable section of this chapter.
Step 2 If the reporting card is an ML-100T-8 or CE-100T-8 card and automatically resets more than once a
month with no apparent cause, complete the “Physically Replace a Card” procedure on page 2-154.
Caution Always use the supplied electrostatic discharge wristband when working with a powered ONS 15310-CL
or ONS 15310-MA.