Filter
Top Products
4-5
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 4 Error Messages
EID-2025 This feature cannot be used. Verify that each of the endpoints
of this circuit are running software that supports this feature.
Refer to the error or warning message text.
For example, this error is generated from
the node view Provisioning> WDM-ANS>
tabs to indicate that the selected ring type is
not supported by the endpoints of the
circuit. Another example is the
Provisioning> VLAN tabs in card view
(Ethernet card only), where it indicates that
the back-end spanning tree protocol (STP)
disabling is not supported.
EID-2026 Unable to apply {0} request. {1} Error occurred while attempting to switch a
path protection circuit away from a span.
EID-2027 Error deleting circuit drop. CTC could not delete the circuit drop.
EID-2028 Error removing circuit node. CTC could not remove the circuit node.
EID-2029 The requested operation is not supported. The task you are trying to complete is not
supported by CTC.
EID-2030 Provisioning error. There was an error during provisioning.
EID-2031 Error adding node. There was an error while adding a node.
EID-2032 Unable to rename circuit. {0} CTC could not rename the circuit.
EID-2033 An error occurred during validation. {0} There was an internal error while validating
the user changes after the Apply button was
pressed. This error can occur in the Edit
Circuit dialog box or in the BLSR table in
the shelf view (rare condition).
EID-2034 Unable to add network circuits:
{0}
Refer to the error message text.
EID-2035 The source and destination nodes are not connected. Refer to the error message text.
EID-2036 Cannot delete this {0}.
LAN Access has been disabled on this node and this {0} is
needed to access the node.
You cannot delete the DCC/GCC link as it
is needed to access the node.
EID-2037 Application error. Cannot find attribute for {0}. CTC cannot find an attribute for the
specified item.
EID-2038 Invalid protection operation. The protection operation you tried to
execute is invalid.
EID-2040 Please select a node first. You must select a node before performing
the task.
EID-2041 No paths are available on this link. Please make another
selection.
You must select a link that has paths
available.
EID-2042 This span is not selectable. Only the green spans with an arrow
may be selected.
Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description