Filter
Top Products
Cisco EtherSwitch Service Modules Feature Guide
How to Configure the Cisco EtherSwitch Service Module
42
Cisco IOS Release 12.2(25)SEC
Default Settings After Initial Cisco EtherSwitch Service Module Configuration
The Cisco EtherSwitch service module is designed for plug-and-play operation. You need only assign
basic IP information to the Gigabit Ethernet interface on the router representing the Cisco EtherSwitch
service module and open a console session to Cisco EtherSwitch service module. You can then connect
any other devices to the switch ports. If you have specific network needs, you can change the
interface-specific and system- and stack-wide settings.
If you do not configure the internal interface at all, it operates with the default settings listed in Table 2.
This table lists the key software features, their defaults, and where to find more information about the
features.
For information about setting up the initial internal interface configuration (using Express Setup or the
CLI setup program) and assigning basic IP information to the internal interface, see the Catalyst 3750
switch hardware installation guide.
Table 2 Default Settings
Feature Default Setting
IP address None
Domain name None
DHCP DHCP client enabled
DCHP server enabled
1
DHCP relay agent enabled
2
Switch stack Enabled
Switch cluster Disabled
Passwords None defined
TACACS+ Disabled
RADIUS Disabled
System name and prompt Switch
NTP Enabled
DNS
3
Enabled
802.1x Disabled
Port parameters
Operating mode Layer 2 (switchport)
Interface speed and duplex mode Autonegotiate
Auto-MDIX Enabled
Flow control Off
Power-over-Ethernet (PoE) Autonegotiate
SmartPorts macros None defined
VLANs