Filter
Top Products
Cisco EtherSwitch Service Modules Feature Guide
How to Configure the Cisco EtherSwitch Service Module in a Switch Stack
54
Cisco IOS Release 12.2(25)SEC
Sample Output for the show switch Command
The following example shows what appears when you enter the show switch command:
Switch# Role Mac Address Priority State
--------------------------------------------------------
6 Slave 0003.e31a.1e00 1 Ready
*8 Master 0003.e31a.1200 1 Ready
2 Slave 0000.000.0000 0 Provisioned
Setting the Stack Member Priority Value
This section describes how to assign a priority value to a Cisco EtherSwitch service module in a switch
stack from global configuration mode.
Note This task is available only from the stack master.
SUMMARY STEPS
1. configure terminal
2. switch stack-member-number priority priority-number
3. end
4. show switch stack-member-number
DETAILED STEPS
Command or Action Purpose
Step 1
configure terminal
Example:
Switch# configure terminal
Enters global configuration mode.
Step 2
switch stack-member-number priority
priority-number
Example:
Switch (config)# switch 1 priority 2
Specifies the stack member number and the new priority
value for the stack member. The priority value range is 1 to
15.
• You can display the current stack member number by
using the show switch user EXEC command.
Step 3
end
Example:
Switch (config)# end
Returns you to privileged EXEC mode.
Step 4
show switch stack-member-number
Example:
Switch# show switch
Displays information about the switch stack and its stack
member number.