Filter
Top Products
Cisco EtherSwitch Service Modules Feature Guide
Troubleshooting the Cisco EtherSwitch Service Module Software
71
Cisco IOS Release 12.2(25)SEC
You are prompted for the max retry count. Accept the default:
Max Retry Count [10]:
You are prompted to confirm the transfer to the Cisco EtherSwitch service module:
Xmodem send on slot 2 interface 0. Please be sure there is enough space on receiving side.
Continue? [confirm]
The following appears when the image is downloaded to the service module:
Ready to send file...........
Loading anyname/loader_bs.img from 223.255.254.254 (via
GigabitEthernet0/0):!C!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!.!!!!!!.!!!!!!!!!!!!!!!!!!!!!
[OK - 262144 bytes]
!
Verifying checksum... OK (0x4F76)
262144 bytes copied in 22.368 secs (11720 bytes/sec)
Sample Output for the service-module session Command on the Cisco EtherSwitch Service Module
The following example shows what appears when you enter the service-module session command:
Router# service-module gigabitethernet1/0 session
Trying 41.0.0.1, 2130 ... Open
Switch:
Sample Output for the dir flash: Command on the Cisco EtherSwitch Service Module
The following example shows what appears when you enter the dir flash: command:
rommon> dir flash:
Directory of flash:/
4 -rwx 2056 Mar 1 1993 00:01:29 +00:00 vlan.dat
6 -rwx 6636204 Mar 1 1993 00:19:19 +00:00 c3750-i5-mz.122204
7 -rwx 1709 Jan 12 2005 00:56:39 +00:00 config.text
8 -rwx 5 Jan 12 2005 00:56:39 +00:00 private-config.text
32514048 bytes total (19113472 bytes free)
Sample Output for the service-module password-reset Command on the Cisco EtherSwitch Service Module
The following example shows what appears when you enter the service-module password-reset
command:
Router# service-module gigabitethernet2/0 password-reset
Do you want to proceed with password reset process?[confirm]
Starting password reset process...
Wait for 50 secs for password reset process to complete
Router#
[Resuming connection 1 to 100.0.2.1 ... ]
Password reset process is complete...
Base ethernet MAC Address: 00:00:00:20:60:80
Xmodem file system is available.
The password-recovery mechanism is enabled.
The system has been interrupted prior to initializing the
flash filesystem. The following commands will initialize