Filter
Top Products
Cisco EtherSwitch Service Modules Feature Guide
How to Configure the Cisco EtherSwitch Service Module
48
Cisco IOS Release 12.2(25)SEC
Sample Output for Saving the Configuration to NVRAM
The following example shows what appears when you save the Cisco EtherSwitch service module
configuration to NVRAM:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it
in nonvolatile RAM (NVRAM) by selecting option 2.
Enter your selection [2]:2
Shutting Down, Resetting, and Reloading the Cisco EtherSwitch Service
Module
This section describes how to shut down, reset, and reload a Cisco EtherSwitch service module after it
has been installed.
For information on network module installation, see the Cisco Network Modules Hardware Installation
Guide.
SUMMARY STEPS
1. service-module gigabitethernet slot/unit shutdown
2. service-module gigabitethernet slot/unit reset
3. service-module gigabitethernet slot/unit reload
Note The argument slot indicates the number of the router chassis slot for the network module. The argument
unit indicates the number of the daughter card on the network module. For Cisco EtherSwitch service
modules, always use 0.
DETAILED STEPS
Command or Action Purpose
Step 1
service-module gigabitethernet slot/unit
shutdown
Example:
Router# service-module gigabitethernet1/0
shutdown
Performs a graceful halt of the Cisco EtherSwitch service
module operating system. Use the service-module reset
command to power up the service module again.
Note Use this command when removing or replacing a
hot-swappable Cisco EtherSwitch service module
during online insertion and removal (OIR).