Filter
Top Products
Appendix C SGM Command Reference
sgm snmpcomm
C-84
Cisco Signaling Gateway Manager User Guide
OL-5742-01
sgm snmpcomm
Solaris Only
Full Syntax
sgm snmpcomm [name]
Command Description
Enables you to set a new default SNMP read community name. SGM
automatically updates the name in the SNMP parameters file. The default path and
filename for the SNMP parameters file is /opt/CSCOsgm/etc/communities.conf.
You must be logged in as the root user or as a super user to use this command.
List of SGM Commands
• SGM Command Reference, page C-1.
sgm snmpconf
Solaris Only
Full Syntax
sgm snmpconf [filename]
Command Description
Sets the file used for SNMP parameters, such as community names, timeouts, and
retries.
The default path and filename for the SNMP parameters file is
/opt/CSCOsgm/etc/communities.conf. If you installed SGM in a directory other
than /opt, then the file is located in that directory.
When you specify a new path or filename, SGM restarts the servers.
Note The SNMP parameters file uses the HP OpenView format. Therefore, you can set
this path and filename to point to the HP OpenView ovsnmp.conf file in an existing
OpenView system.