Filter
Top Products
4-7
Cisco uBR10012 Universal Broadband Router Troubleshooting Guide
OL-1237-01
Chapter 4 Troubleshooting Line Cards
General Information for Troubleshooting Line Card Crashes
If the crash is accompanied by %IPC-3-NOBUFF messages, see Troubleshooting IPC-3-NOBUFF
Messages on the Cisco 12000, 10000 and 7500 Series, at the following URL:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a00800945a1.s
html
• Hardware Problem—The card might not be fully inserted into its slot, or the card hardware itself
could have failed. In particular, if the problem began occurring after the card was moved or after a
power outage, the card could have been damaged by static electricity or a power surge. Only a small
number of fabric ping timeouts are caused by hardware failures, so check for the following before
replacing the card:
–
Reload the software on the line card, using the hw-module slot reset command.
–
Remove and reinsert the line card in its slot.
–
Try moving the card to another slot, if one is available.
If software-forced crashes continue, collect the following information and contact Cisco TAC:
• All relevant information about the problem that you have available, including any troubleshooting
you have performed.
• Any console output that was generated at the time of the problem.
• Output of the show tech-support command.
• Output of the show log command (or the log that was captured by your SYSLOG server, if
available).
For information on contacting TAC and opening a case, see the “Obtaining Technical Assistance” section
on page x.