Filter
Top Products
VIP-FE-TX/4E Installation and Configuration 55
VIP Port Adapter Functions
Table 16 4E Slot, Port Adapter, and Port Numbers in a Cisco 7507
Table 17 4E Slot, Port Adapter, and Port Numbers in a Cisco 7513
With the show interfaces type slot/port adapter/port command, use arguments such as the interface
type (ethernet, and so forth) and the slot, port adapter, and port numbers (slot/port adapter/port) to
display information about a specific Ethernet 10BASE-T interface only.
The following example of the show interfaces ethernet slot/port adapter/port command shows all
of the information specific to the first 4E interface port (interface port 0) in chassis slot 3, port
adapter slot 1:
Router# sh int e 3/1/0
Ethernet3/1/0 is administratively down, line protocol is down
Hardware is cyBus Ethernet, address is 0000.0ca5.2300 (bia 0000.0ca5.2388)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 4:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 2:56:26
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets, 0 restarts
0 output buffer failures, 0 output buffers swapped out
Note For complete VIP command descriptions and examples, refer to the publications listed in the
section “If You Need More Information” on page 2.
Slot 0/
Adapter 1/
Port n
Slot 1/
Adapter 1/
Port n
Slot 4/
Adapter 1/
Port n
Slot 5/
Adapter 1/
Port n
Slot 6/
Adapter 1/
Port n
0/1/0 1/1/0 4/1/0 5/1/0 6/1/0
0/1/1 1/1/1 4/1/1 5/1/1 6/1/1
0/1/2 1/1/2 4/1/2 5/1/2 6/1/2
0/1/3 1/1/3 4/1/3 5/1/3 6/1/3
Slot 0 /
Adapter
1
/
Port
1. The 4E port adapter is always installed in port adapter slot 1 on the VIP.
Slot 1 /
Adapter/
Port n
Slot 2/
Adapter/
Port n
Slot 3/
Adapter/
Port n
Slot 4/
Adapter/
Port n
Slot 5/
Adapter/
Port n
Slot 8/
Adapter/
Port n
Slot 9/
Adapter/
Port n
Slot 10/
Adapter/
Port n
Slot 11/
Adapter/
Port n
Slot 12/
Adapter/
Port n
0/1/0 1/1/0 2/1/0 3/1/0 4/1/0 5/1/0 8/1/0 9/1/0 10/1/0 11/1/0 12/1/0
0/1/1 1/1/1 2/1/1 3/1/1 4/1/1 5/1/1 8/1/1 9/1/1 10/1/1 11/1/1 12/1/1
0/1/2 1/1/2 2/1/2 3/1/2 4/1/2 5/1/2 8/1/2 9/1/2 10/1/2 11/1/2 12/1/2
0/1/3 1/1/3 2/1/3 3/1/3 4/1/3 5/1/3 8/1/3 9/1/3 10/1/3 11/1/3 12/1/3