Filter
Top Products
Configuring the WAP4410N Wireless-N Access Point
Setting Up Your Access Point
WAP4410N Wireless-N Access Point with Power Over Internet 20
6
Configuring Device Setup Settings
To configure the device setup settings of the access point, follow these steps:
STEP 1 Click Setup > Basic Setup.
STEP 2 In the Device Setup section, enter the following information:
• Host Name—Enter the host name of the access point.
You can use the host name to access the web-based configuration utility
through the network if a record of the host name exists in your DNS server.
The access point publishes the host name to your DNS server if you
configured the access point to acquire its IP address from a DHCP server.
Follow your organization’s policy when assigning this name.
The default name is Cisco.
• Device Name—Enter the device name for the access point.
This name is identification purposes only. Unique, memorable names are
helpful, especially if you are deploying multiple access points on the same
network. This name helps you identify the access point after you log in.
The default name is WAP4410N.
STEP 3 Click Save.
Configuring Network Setup Settings
To configure the network setup settings of the access point, follow these steps:
STEP 1 Click Setup > Basic Setup.
STEP 2 From the IP Settings drop-down menu, select one of the following options:
• Static IP Address—Select this option to assign a static or fixed IP address
to the access point.
• Automatic Configuration—Select this option to automatically configure
the IPv4 network settings of the access point using a DHCP server on your
network. Also select this option to automatically configure the IPv6 network
settings of the access point using an IPv6 RADVD device enabled on your
network.