Configuring the WAP4410N Wireless-N Access Point
Setting Up Your Access Point
WAP4410N Wireless-N Access Point with Power Over Internet 21
6
STEP 3 If you select Static IP Address from the IP Settings drop-down menu, enter the
following information in the IP4V section of the screen:
• IP Address—Enter a unique IP address for your access point. The default IP
address is 192.168.1.245.
• Subnet Mask—Enter the same subnet mask used in your network. The
default is 255.255.255.0.
• Default Gateway—Enter the IP address of your Gateway or Router. Enter
the value used by other devices on your LAN.
• Primary DNS—Enter the IP address of your primary DNS server.
• Secondary DNS—Enter the IP address of your secondary DNS server.
STEP 4 To configure the IPv6 settings for your access point:
• IPv6—Select Enabled to enable IPv6 for your access point.
• Accept Router Advertisement—Check this check box to accept router
advertisement.
• Local IP Address—Enter a unique IP address for your access point.
• Default Gateway—Enter the IP address of your gateway or router. This
address is used by the other devices on your network.
• Primary DNS—Enter the IP address of your primary DNS server.
• Secondary DNS—Enter the IP address of your secondary DNS server.
STEP 5 Click Save.