Filter
Top Products
— 142 —
GS <
[Function] Initializing the printer mechanism
[Code] <1D>H<3C>H
[Outline] Perform a label initialization identical to power-on initialization.
[Caution] This command is valid only if "label" is chosen.
• Parameters configured by commands are not reset.
GS A m n
[Function] Correcting the label top position
[Code] <1DH><41>H<m><n>
[Range] 0
m 255
0
n 255
[Outline] This command sets the label head position in terms of correction
value the default position.
• m denotes the correctingdirection and valid only for the least
• significant bit(m0).
[Caution] • This command is valid only if "label" is chosen.
• This command is ignored immediately after the execution of a
leader positioning command (FF, GS FF, GS A, GS <) or
immediately after leader positioning performed on a paper
feed action with the FEED switch, power on, or cover closure.
• The maximum reverse correction span is 0.5 mm. Correction
settings exceeding this value are truncated into the maximum
value. The label may be mispositioned due to paper flexure.
For reverse correction, exercise care so the leader position
does not step out of the label.
• For forward correction, set the correction span by taking into
account the label length as the printable area changes before
and after correction setting.
• In calculating a correction span, use the calculated basic feed
span for the vertical direction. The fractional part contained in
the calculation result should be used for correction at an
increment of the mechanism's minimum feed span, with the
remaining fractional part truncated.
[See Also] FF, GS FF
m0 Correcting direction
0 Corrects in the forward direction
1 Corrects in the reverse direction