Filter
Top Products
— 8 —
2.3.4 Sensor Position and Cutter Position
Black mark sensor position
(11mm) (40mm)
(18mm) (12mm)
Label interval
Sensor position
(27mm)
CAUTION:
Observe the following rules on the usage of the auto cutter:
• Every cut paper should be no less than 10 mm in length.
• When cutting a label roll, be sure to cut the base sheet. Never cut labels (tags).
Manual cutting position
Auto cutting position
Top print line
Paper feed direction
CAUTION:
When using label sheet:
• Be sure to cut the base sheet at every label gap. Otherwise, the cutter performance
will be immensely degraded.
• Never open the printer cover while printing as proper print operation may not be
guaranteed. Opening the printer cover may alter label length setting or other
parameters.
• Never use label rolls with different label sizes or label gaps as proper print
operation will not be guaranteed.
Peeler sensor position
CAUTION:
• With a label roll using black marking, the printer could print in label gaps. The user
should take the necessary corrective action to avoid this.
• If black marking is used for label sensing, the printer can print over cut lines. This
requires the appropriate user adjustment, however.