Filter
Top Products
— 21 —
Buzzer-on Timing
If either of the following printer errors occurred, the buzzer sounds and the
ERROR LED comes on:
1. Paper-End (PE) or Cover Open
Four short "pip" tones sound in 2 cycles at a 0.5-sec. interval.
2. Auto Cutter Error
A continuous "pip" tone and "peep" tone sounds for 1 sec.
Waiting for label cutter action:
Wait until the label discharged by the GS+FF (Cut Label &
Discharge) command is cut by the manual cutter and the
FEED switch is pressed.
If "No Cutter" or "No Peeling Mechanism" is chosen, the
printer becomes Busy.
Label detection error:
Label gaps or black marks could not be detected, or the label
sheets used do not fall in the specified length limits.
If a label detection error occurs even though the label sheets
used fall in the specified length limits, it is most likely that the
sensor or its peripheral electronics is defective. The printer
becomes Busy.
Waiting for label peeling action:
Wait until the label discharged by the GS+FF (Cut Label &
Discharge) command is peeled off the base sheet. If the
"Peeling Mechanism" is chosen, the printer becomes Busy.
FEED switch
• Pressing this switch briefly causes one line of paper feeding. Holding down the
switch causes continuous paper feeding.
• While a macro is waiting to be executed, pressing the switch causes the macro
to be executed.
FEED switch and POWER switch
If you press the POWER switch while holding down the FEED switch, self printing
is performed.