Filter
Top Products
Chapter 2 PrinterOparetion
29
6 Returning to Factory Setting
To return the configuration already set in the printer setup mode or system maintenance mode
to the factory setting, proceed as follows:
Turn off the power switch. Press and hold the Pause, Feed and Stop keys simultaneously while
turning on the power switch, and further continue holding down those keys.
F
F
a
a
c
c
t
t
o
o
r
r
y
y
s
s
e
e
t
t
t
t
i
i
n
n
g
g
Printer setup mode System maintenance mode
Mode item Indication Mode item Indication
Printing mode Transfer Baud rate 9600bps
Peeling sensor PeelOFF Data length 8bits
Auto-cutter CutOFF Native NativeON
Tearing TearOFF Feed amount fVirtual
Sensor selection Edge Command code CmndSTD
Interpreter INTP STD Adjustable sensor AJSensOF
Voltage setting PE ∗.∗∗ V
Press and hold those keys
simultaneously while turning on
the power switch
You hear a ‘Pi’ sound. Further continue
holding down those keys
When you again hear a ‘Pi’ sound,
the operation is completed