Filter
Top Products
Appendixes
74
2 Specifications
Cut Position Adjustments
• The cut position can be specified with the ‘fnnn’ of the system -level commands. When the
tear-off function is turned on, the following initialization value is set in the printer.
Initialization value: fnnn = f735 (73.5 mm)
The values higher or lower will increase or decrease the amount of feed in the tear-off.
• Parameter initialization values
Initialization values of print and feed positions by each operating mode are described below.
unit: mm (in)
Normal
printing
Auto-cutter Peeling Tear-off
Minimum
value
Print position
(Onnnn, form offset)
55.9 (2.2) 55.9 (2.2) 55.9 (2.2) 55.9 (2.2) 12.7 (0.5)
Feed position (fnnn) 55.9 (2.2) 86.4(3.4) 68.6(2.7) 73.7(2.9) 12.7(0.5)
Paper position sensor
Onnnn: Paper position setting
fnnn: Feed position setting
Fnnn <= Onnnn
Feed or back-feed is not
performed
Fnnn > Onnnn
Feed or back-feed is performed
Print head
Onnnn
fnnn
Cutter
Peeler
Tear-off