Filter
Top Products
Chapter 2 Safety Precautions
-
--
-
6 -
--
-
Avoid high-humidity areas
Do not put the printer in areas with high-humidity or heavy
condensation. If moisture has condensed on the printer, turn off
the power switch immediately and leave the printer for a while
until the moisture dries up. Using the printer when damp may
result in electrical shock.
Carrying
Before carrying the printer, be sure to remove the plug from the
outlet and the connecting cable to the outer equipment. If left
connected, the power cord and connecting cable may be
damaged, leading to fire and electrical shock.
Do not transport the printer while loaded with media. If media is
loaded, it may drop out, leading to injury.
When placing the printer on a floor or desk, be careful not to
catch your fingers and hands under the feet of the printer.
Power
Never operate the power switch or insert/remove the power or
data cord with wet fingers. Failure to observe this precaution may
result in electrical shock.
Power cord
Do not put a heater near the power cord. A nearby heater can
melt the power cord casing, resulting in fire or electrical shock.
When removing the plug of the power cord from the outlet, be
sure to grip the plug, not the cord, when pulling it out. Pulling the
cord may expose the core or break the wire, leading to fire or
electrical shock.
CAUTION