Filter
Top Products
Chapter 4 Media (Paper) and Ribbon
-
--
-
24
-
--
-
2 Two ribbon bobbins are used for loading ribbon; one is inserted in the source (unused) ribbon core
and the other is inserted in the destination ribbon core. And wind ribbons two or three times around
the destination ribbon core by hand.
NOTE
The following procedure may help you load the ribbon more easily. First insert the bobbins
into the source and destination ribbon cores, affix the adhesive tape at the end of the ribbon
and then wind the ribbon around the bobbin until the tape is hidden. Finally, set the ribbon by
passing it through the lower side of the printhead assembly.
CAUTION
Be sure to wind the ribbon sufficiently over the adhesive clear tape fastened to the end of the
ribbon.