Filter
Top Products
Chapter 4 Media (Paper) and Ribbon
-
--
-
22
-
--
-
7 The roll media is now loaded. Lastly close the top cover.
Fanfold media
1 Remove ribbon holder disks (two) from the ribbon holder assembly. Place the paper holder shaft onto
the round cuts on the paper guides and paper holder shaft supporting plates on both sides.
2 Place the fanfold media on firm, level surface in the back of the printer and route it through the
opening between top and lower bottom covers on the back of the printer, over the paper holder shaft
and platen out to the top of the printer. Other loading procedures are same as for roll media (see
P19-22).
Paper holder shaft