Filter
Top Products
Chapter 3: Setting up the Printer20
A799 Two-Color Thermal Receipt Printer: User Guide A799-UG00001 Rev. D 11/2012
Power supply cable
To avoid damaging the printer, connect the power supply last.
1 Plug the power cable into the power supply connector shown in the center of the illustration above.
2 Close the connector cover until it snaps, making sure that all the cables are aligned with the slots in the connector cover.
Double-check that the strain relief on the connector cover is aligned with the power supply cable (see “Cable routing”
section which follows).
3 Plug the power cord into the power supply.
4 Plug the power supply into a grounded outlet. When it is properly powered, the green LED on the top of the printer will
light up.
WARNING! Using this device without a grounded outlet is a safety hazard and voids the printer Warranty, Safety, FCC
and CE Mark designation.
Ethernet communication cable
Ethernet communication connector panel
Ethernet
connector
Power
supply
connector
1 You don’t need to turn off the computer. Plug the printer end of the Ethernet cable into the Ethernet connector port on
the printer (A). Make sure the connector snaps rmly in place.
2 Plug the computer end of the Ethernet cable into the Ethernet port of the computer. Make sure the connector snaps
rmly in place.
3 After you have connected the printer, you may need to set the printer internal parameters for Ethernet operation. See
Ethernet Setup Guide.
Power
Supply
Connector
Connector Interface Panel