Filter
Top Products
Chapter 4: Using the Printer24
A799 Two-Color Thermal Receipt Printer: User Guide A799-UG00001 Rev. D 11/2012
1 Turn power off to printer.
2 Open connector cover (1).
3 Set DIP switch 1 to the ON position (down) (2).
DIP switch 2 should be in the OFF position (up).
4 Make sure receipt paper (3) is loaded in the printer
before proceeding. Make sure cover is closed.(See page
12.)
5 Apply power to printer and immediately press and hold
the paper feed button (4) until the conguration printout
begins.
• The printer beeps, then prints the diagnostics form
and the conguration main menu.
• The printer pauses and waits for a main menu
selection to be made (see sample printout on the
next page; short clicks are used, except when
answering “yes” or validating selection).
6 To communicate with the printer, you will press the
paper feed button using either short or long clicks. Use
a long click for “yes” (more than one second) and a
short click for “no.” Follow the printed instructions to
make selections.
7 Continue through your menu selections until you are
asked, “Save New Parameters?” Select “Yes.”
a Return DIP Switch 1 to the OFF position (up).
b Reset the Printer.
c Open the receipt cover.
Press and hold the paper feed button while closing
the receipt cover.
• The diagnostic printout veries your new settings.
To enter the conguration mode: