Filter
Top Products
Chapter 4: Using the Printer 25
11/2012 A799-UG00001 Rev. D A799 Two-Color Thermal Receipt Printer: User Guide
Print test and Conguration menu samples. Samples will vary depending on the printer model.
(Shown approximately 60% of size)
Short clicks are used in the main menu selections.
- Set Firmware Features - > 8 clicks
*** A799 - Diagnostics Form ***
Model number : A799-120D-TD00
Serial number : 0000000000
Boot Firmware
Revision : V3.02
CRC : 7E22
P/N : 189-7940489B
Flash Firmware
Revision : V3.01
CRC : 4448
P/N : 189-7940490A
H/W parameters
Flash Memory Size : 4 Mbytes
Flash Logos/Fonts : 1024 kbytes
Flash User Storage : 960 kbytes
Flash Perm’nt Fonts : 960 kbytes
Flash Journal Size : 128 kbytes
SRAM Size : 512 kbytes
Head settting : D
Motor ID : 1
Paper Type Setting : Type 0, Monochrome
Color Density Adj : n/a
Print Density, Mono : 100%
Max Speed : 250 mm/sec
Paper Width : 80 mm
Max Power : 55 W
Knife : Enabled
Partial Cut : 125 steps
Paper Low Sensor : Enabled
No Paper Low Extension
Comm. Interface
RX Buer Size : 4096
Interface Type : RS232/USB
Parameters
Baud Rate : 115200
Data Bits : 8
Stop Bit : 1
Parity : NONE
Flow Control : DTR/DSR
Reception Errors : Ignore
USB Driver Type : Printer Class
USB Packet w/Error : Reject
When the printer is congured for USB, this
location will show either: “USB Driver Type: Native”,
“USB Driver Type: Printer Class”, or “USB Driver:
Comm Class.”