Filter
Top Products
Initial Configuration 31
© 2009 Datacom Systems Inc
Step 8. SET IP (SE IP) by typing se ip xxx.xxx.xxx.xxx corresponding to a valid IP address for
your network. Press the Enter key to continue.
Step 9. SET SUBNET (SE SU) by typing se su xxx.xxx.xxx.xxx corresponding to your
network's subnet mask. Press the Enter key to continue.
Step 10. SET GATEWAY (SE GA) (if needed) by typing se ga xxx.xxx.xxx.xxx corresponding
to your network's default gateway. Press the Enter key to continue.
Step 11. SHOW (SH) by typing sh and press the Enter key to display and affirm that the pending
IP Address, IP Subnet and IP Default Gateway match the intended Local Area Network input IP
Address, IP Subnet and IP Default Gateway.
Step 12. If the pending IP Address is not correct, repeat Step 8, if the pending IP Subnet is not
correct, repeat Step 9 and if the pending IP Default Gateway is not correct, repeat Step 10.
Repeat Step 11 to review and verify that the pending IP Address, IP Subnet and IP Default
Gateway match the intended Local Area Network input IP Address, IP Subnet and IP Default
Gateway.