Filter
Top Products
Initial Configuration 41
© 2009 Datacom Systems Inc
4.6.3 Installing the SFP Module
SFP modules might ship already installed in your VS-1200, or they might arrive packaged
separately. This section describes how to install the SFP module.
NOTE: You can install SFP modules with power on to the system; however, it is strongly
recommended that you do not install the SFP module with fiber or copper cables attached to it.
Disconnect all cables before installing a SFP module.
CAUTION: Prevent system problems, use only Datacom Systems Inc. supplied SFP modules.
Step 1. Turn the SFP module so the latch is towards the center of the Gigabit Ethernet Interface
sockets. The SFP module is keyed so that it cannot be inserted incorrectly.
Step 2. Insert the SFP module into the SFF port and repeat Step 1 and Step 2 inserting other SFP
modules until completed.
Step 3. Attach the appropriate network cable to the LC-type or RJ45-type connector on the SFP
module. For fiber optic SFP modules you can use either simplex or duplex connectors. For simplex
connectors, two cables are required, one cable for transmit (Rx) and a second cable for receive
(Rx). For duplex connectors, only one cable that has both Tx and Rx connectors is required.
4.6.4 Removing the SFP Module
SFP modules might ship already installed in your VS-1200, or they might arrive packaged
separately. This section describes how to remove the SFP module.
NOTE: You can remove SFP modules with power on to the system; however, it is strongly
recommended that you do not remove the SFP module with fiber or copper cables attached to it.
Disconnect all cables before removing a SFP module.
Step 1. Disconnect the network cable from the SFP module LC-type or RJ45-type connector.
Step 2. Release the SFP module from the GE SFF port by moving the swing latch away from the
body of the unit.
Step 3. Slide the SFP module out of the GE SFF port.