Filter
Top Products
PE Series Operator’s Manual
11
p Peel the first 12 inches of label material from the liner and
discard.
; Note: If you wish to leave the label attached to the liner do not
thread the media through the Drive Plate.
Figure 3-4 Media Loading
q Feed the liner as shown in Figure 3-4. Be sure that the liner
passes through the “fingers” of the Label Edge Sensor.
Continue feeding the liner, bringing it under the Drive Plate
Hinge Pin (see Figure 3-5). Pull through removing any slack.
; Note: When using narrow media, it may be necessary to adjust the
position of the Label Edge Sensor to ensure detection. This
is done by turning the Edge Sensor Adjustment Knob (see
Figure 2-3).