Filter
Top Products
PE Series Operator’s Manual
15
3.4 Ribbon Removal
Removal of a Partially Used Roll of Ribbon
Complete the following steps to remove and save a ribbon:
n Cut the ribbon at the point shown in Figure 3-8.
o Turn the Ribbon Take-up Hub until the end of the ribbon
has cleared the printhead area.
p Grasp the roll of used ribbon and slide the used ribbon
straight off the Ribbon Take-up Hub. Discard the used
ribbon.
q Grasp the roll of unused ribbon, pull and slide the unused
ribbon from the Ribbon Supply Hub, storing it for future use.
Figure 3-8 Ribbon Cutting Point