Filter
Top Products
PE Series Operator’s Manual
33
QF!Pqujpot
(cont.)
Backfeed Cntrl
Controls the timing associated with the backfeeding
of a presented label.
*20 ms after print
20 millisecond delay before printing the next label.
40 ms after print
40 millisecond delay before printing the next label.
60 ms after print
60 millisecond delay before printing the next label.
80 ms after print
80 millisecond delay before printing the next label.
99 ms after print
99 millisecond delay before printing the next label.
no backfeed
Disables all backfeed motion.
before print
Backfeeds without delay, upon next print cycle.
Ribbon Low
Sets the output polarity of the applicator port pin #2
ribbon low signal.
*Active Low
Signal goes low for ribbon low condition.
Active High
Signal goes high for ribbon low condition.
Sjccpo!Mpx!Ejb
/
Allows user to select how much ribbon will remain
when a Low Ribbon message is displayed.
*20
Value range: 14-34
The value selected is the remaining diameter in
tenths of an inch.
Qsjoufs!Npefm
Instructs the printer of the mechanism’s configuration
for printhead zero dot orientation.
*Left Hand
Right side label output.
*Right Hand
Left side label output.
Dpvoufst
Read only check of the printer’s absolute values.
Absolute Values
Given in inches; not resettable.
Ebuf0Ujnf
Allows the current date and time fields to be
changed.
Mbcfm!Pqujpot
Allows access to six label parameters.
Heat Setting
Allows the selection of different heat settings.
Changes the "on time" of the printhead dots.
*10
Value range: 0-30
The higher value, the darker the print.