Filter
Top Products
19
INSTALLATION- Rack Mounting
RACK MOUNTING
Rack mounting of the DCM is optional. Four, self-adhesive rubber feet are included with your DCM for non-
rack mount applications. If using the DCM in non-rackmount applications, we recommend the rubber feet be
installed on the bottom of your DCM to minimize the chances of scratching any supporting surface. To use
the self-adhesive feet: peel off the protective backing from the foot, place near one of the corners on the
bottom, and press firmly to activate the pressure-sensitive adhesive.
If rack mounting the DCM, secure the DCM to the rack rails using four machine screws and washers of the
proper size. Most US rack equipment accepts #10-32 machines screws; length used depends upon applica-
tion. The DCM will require 3-RU (rack units) of space.
To rack mount your DCM:
1- select mounting location
2- have an assistant support the DCM in its mounting location
3- secure the two bottom screws first; do not fully tighten yet
4- secure the top two screws, do not fully tighten yet
5- “fine tune” the DCM up, down, right, or left as required and tighten the four mounting screws