Filter
Top Products
Replacing Parts 55
11 Insert the battery into the battery bay, or connect the AC adapter to
your computer and an electrical outlet.
12 Turn on the computer.
As the computer boots, it detects the additional memory and automatically
updates the system configuration information.
Replacing the Hard Drive
NOTICE: To prevent data loss, turn off your computer (see page 20) before
removing the hard drive. Do not remove the hard drive while the computer is
on, in standby mode, or in hibernate mode.
NOTICE: Hard drives are extremely fragile; even a slight bump can damage
the drive.
CAUTION: If you remove the hard drive from the computer when
the drive is hot, do not touch the metal housing of the hard drive.
CAUTION: Before working inside your computer, read "Safety and
Use Instructions" on page 7.
HINT: Dell does not
guarantee compatibility
or provide support for
hard drives from sources
other than Dell.
To replace the hard drive in the hard drive bay:
1 Make sure that the work surface is flat and clean to prevent scratching
the computer cover.
2 Save and close any open files, exit any open programs, and shut down
the computer (see page 20).
3 Disconnect the computer from the electrical outlet.
4 Wait 10 to 20 seconds and then disconnect any attached devices.
5 Remove any installed PC Cards, battery, and devices.
Handle components and cards by their edges, and avoid touching pins
and contacts.
6 Ground yourself by touching a metal connector on the back of the
computer, and continue to do so periodically during this procedure.