Filter
Top Products
Troubleshooting Tools 75
INVALID CONFIGURATION INFORMATION - PLEASE RUN SETUP PROGRAM —Enter
System Setup (see "Viewing the System Setup Screens" on page 102) and
change System Setup options (see "Commonly Used Options" on page 102)
to correct the configuration error.
KEYBOARD FAILURE — Keyboard failure or keyboard cable loose (see "Lockups
and Software Problems" on page 88).
MEMORY ADDRESS LINE FAILURE AT (ADDRESS), READ VALUE EXPECTING
(
VALUE)—See "Lockups and Software Problems" on page 88.
MEMORY DOUBLE WORD LOGIC FAILURE AT (ADDRESS), READ VALUE EXPECTING
(
VALUE)—See "Lockups and Software Problems" on page 88.
MEMORY ODD/EVEN LOGIC FAILURE AT (ADDRESS) READ VALUE EXPECTING
(
VALUE)—See "Lockups and Software Problems" on page 88.
MEMORY WRITE/READ FAILURE AT (ADDRESS), READ VALUE EXPECTING
(
VALUE)—See "Lockups and Software Problems" on page 88.
MEMORY SIZE IN CMOS INVALID — See "Lockups and Software Problems" on
page 88
.
NO BOOT DEVICE AVAILABLE – STRIKE F1 TO RETRY BOOT, F2 FOR SETUP UTILITY.
PRESS F5 TO RUN ONBOARD DIAGNOSTICS —The system cannot detect a
bootable device or partition.
• If the floppy drive is your boot device, ensure that the drive is installed
properly and that a bootable floppy disk is in the drive.
• If the hard drive is your boot device, ensure that the drive is installed
properly and partitioned as a boot device.
• Enter System Setup and ensure that the boot sequence information is
correct (see "Viewing the System Setup Screens" on page 102).
NO BOOT SECTOR ON HARD-DISK DRIVE — Enter System Setup and ensure that
the configuration information for the hard drive is correct (see "Viewing the
System Setup Screens" on page 102)
.
NO TIMER TICK INTERRUPT — Run the Dell Diagnostics (see "Dell
Diagnostics" on page 79).
NON-SYSTEM DISK OR DISK ERROR — Replace the floppy disk with one that has
a bootable operating system or remove the floppy disk and restart the
computer.
NOT A BOOT DISKETTE — Insert a bootable floppy disk and restart your
computer.
book.book Page 75 Wednesday, December 12, 2007 10:32 AM