Filter
Top Products
Replacing the Processor Heat Sink/Fan Assembly
1. Apply thermal solution to the heat sink as needed.
2. Align the four captive screws on the heat sink/fan assembly with the holes and rubber bushings on the system board.
3. Tighten the captive screws evenly to secure the heat sink/fan assembly to the system board.
4. Attach the heat sink/fan assembly cable to the system board (see System Board Components).
5. Follow the procedure in After Working on Your Computer.
Back to Contents Page
NOTICE: Unless a new heat sink is required for the new processor, reuse the original heat sink/fan assembly when you replace the processor.
1
Phillips screwdriver
2
heat sink/fan assembly
3
heat sink/fan cable
4
system board fan connector
5
screw holes with rubber bushings
6
captive screws (4)
NOTICE: Ensure that the assembly is correctly seated and secure.